Home EV Charger Installation in St. John’s, NL: A Homeowner’s Guide

Most EV owners in St. John’s do the bulk of their charging at home. A properly installed charger in your garage or driveway makes owning an EV far more convenient, but it is not a simple plug-and-go job. This guide walks through your options, what has to be checked before installation, and how the permit process works for home EV charger installation in St. John’s, NL and nearby communities.

Level 1 vs. Level 2 Charging at Home

Most EVs come with a cord that plugs into a standard household outlet. This is called Level 1 charging. It needs no new equipment, but it is slow and is best suited to drivers who travel short distances or have a plug-in hybrid.

A Level 2 charger runs on a 240-volt circuit, similar to the one used by an electric dryer or range. It charges several times faster than Level 1, so most drivers can plug in when they get home and start the next day with a full battery. For most households, a Level 2 charger is the practical choice, and it is the type that requires an electrician.

Can Your Home’s Electrical System Handle a Charger?

A Level 2 charger is one of the largest loads in a typical home, and it can run for hours at a time. Before anything is installed, an electrician should look at:

  • Your service size: the amperage of your electrical service and how much of it your home already uses.
  • Your panel: whether there is room for a new double-pole breaker and whether the panel is in good condition.
  • The load calculation: a calculation under the Canadian Electrical Code that shows the service can carry the new load safely.
  • The route: the distance from the panel to the charging location, which affects wire size and cost.

Many older homes around St. John’s were built long before EVs existed. If the load calculation shows your service is too small, you may need an upgrade first. Our page on panel upgrades in St. John’s explains what that involves.

Load management as an alternative to an upgrade

The Canadian Electrical Code allows an Electric Vehicle Energy Management System (EVEMS). This is a device that monitors your home’s electrical use and automatically reduces or pauses charging when other large appliances are running. In some homes, an EVEMS can make it possible to add a charger without a full service upgrade. Your electrician can tell you whether it is a good fit for your home.

Doing It Yourself vs. Hiring a Professional

Installing a Level 2 charger means adding a dedicated 240-volt circuit, sizing the breaker and wire correctly, and mounting and connecting the equipment to the manufacturer’s instructions. Mistakes can lead to overheating, tripping breakers or a fire risk.

In Newfoundland and Labrador, electrical permits are only issued to registered electrical contractors. The one exception is a certified journeyperson electrician working on their own property. For most homeowners, that means a charger installation should be done by a registered contractor who handles the permit and inspection.

Permits and the Canadian Electrical Code

Electrical work in the province must meet the Canadian Electrical Code, Part I. The 2024 edition has been enforced in Newfoundland and Labrador since July 1, 2024. Section 86 of the Code covers EV charging equipment and generally requires a charger to be on its own branch circuit, unless an energy management system is used.

A permit is needed before the work starts. Inside the City of St. John’s, electrical permits are handled by the City. In many surrounding communities, they are issued through the province’s Government Service Centre. Either way, your contractor should apply for the permit, complete the work and arrange the inspection.

Choosing a Charger and a Location

When you pick a charger, check that it is certified for use in Canada (look for a recognized certification mark such as CSA or cUL) and that it is compatible with your vehicle. If it will be mounted outside, make sure it is rated for outdoor use. Our winters bring wind, freezing rain and plenty of snow, so think about where the cable will sit, how you will clear snow around it, and whether the unit is protected from snowplow spray in the driveway.

Inside a garage, the best spot is usually close to the vehicle’s charging port when parked, which keeps the cable short and off the floor.

About ShockFree Electrical

ShockFree Electrical Inc. is based at 24A Mews Pl in St. John’s and serves homeowners in St. John’s, Mount Pearl, Paradise, Conception Bay South, Torbay, Portugal Cove-St. Philip’s, Flatrock and Holyrood. The company is rated 4.9 stars from 195 Google reviews. If you are planning a home EV charger installation, you can reach the team at 709-600-4940 or through our contact page.

Frequently Asked Questions

Do I need a permit to install an EV charger in St. John’s?

Yes. A Level 2 charger needs a new circuit, which requires an electrical permit before work begins. Your electrical contractor should get the permit and arrange the inspection.

Will I need a panel upgrade for a Level 2 charger?

Not always. A load calculation will show whether your current service can handle the charger. If it cannot, a service or panel upgrade, or an energy management system that controls charging, may be the solution.

ShockFree Electrical Logo Sq

Contact Us

Get started today by completing the form below and one of our team members will get back to you as soon as possible.